Mike Baglier

Operators often believe that they can only cut steel when using a traditional oxy-fuel hand-cutting torch. Did you know that this same torch could also cut titanium? It’s possible, as long as the operator considers a few aspects such as cutting speeds, proper personal protection equipment (PPE), and the right tip for the job.

Cutting speeds will increase up to 50% when cutting titanium. This is because titanium accepts oxygen at a much faster rate at higher temperatures. This requires consideration of the tip size. Due to the attraction of titanium and oxygen, the tip size should be 50% to 75% of the tip size recommended for mild steel at the same thickness. (Example: For 2″ titanium, the operator should use a tip recommended for 1″- 1 1/2″ of steel). The operator must determine the tip size needed based upon the quality of the cut. Consider using a machine torch tip when cutting titanium if it is not a scraping operation. The result is a higher quality cut with a smaller kerf, thus reducing costs.

In addition to the normal PPE required for oxy-fuel cutting, the operator must wear a proper respirator. This reduces the chance of inhaling titanium oxides from the dust and excessive smoke produced when cutting titanium. The operator should also use a #5-shade face shield rather than glasses to reduce the chance of injury due the intense sparks produced, as they can travel further distances. As added precaution, the operator should ensure that the surrounding work area is hazard-free.

Mike Baglier

Mike Baglier is a Technical Sales Representative going on two years at The Harris Products Group, currently serving a California/Nevada portfolio. Mike was initially placed on the Spec Gas team before being transferred to a West Coast industrial sales position, giving him a deep understanding of our spec gas and gas distribution product lines. Mike is based out of our Santa Fe Springs, CA office.